Tuckers Air Conditioning, Heating & Plumbing Blog: Posts Tagged ‘Heating Replacement’

Heating Replacement Tip: Signs of an Undersized Furnace

Wednesday, January 18th, 2012

If you’re purchasing a new furnace for your Rockville home, you want to avoid buying one that is undersized for your particular space. To do that, here are some common signs that the furnace isn’t powerful enough for the heating needs of your home. These signs might appear for an older furnace as well, especially as it ages and loses its ability to provide adequate heat for your home.

Maintaining Temperature

The most common (and in many cases only) sign that your furnace is undersized is that the device simply doesn’t maintain the temperature in your home properly. This means that when turned on to full and left for a few hours, your furnace doesn’t heat your home to the thermostat setting.

This can be due to an improper load calculation or a load calculation that wasn’t taken at all. The perfectly sized furnace will heat your home evenly on the coldest day your area is likely to have. So, undersizing should be pretty evident – if it doesn’t heat your home evenly and it’s not exceptionally cold outside, you might not have enough BTUs under the hood.

How to Fix the Problem

The problem is one that varies depending on the severity of the undersizing. Modern furnaces are often available with two stages, meaning they can operate at both a low BTU rating (often around 40K or so) and a higher BTU rating (70K or higher). This is the perfect solution for homeowners worried about undersizing because it ensures that your home always has enough heat in reserve should the weather get exceptionally cold.

For example, most furnaces are sized for extremely low temperatures, but if the temperature jumps up to 50 degrees F outside, your furnace is now oversized for that weather. A two stage furnace offers solutions for both common conditions and extreme conditions and will resolve most of the concern you have about undersizing and not having enough heat to offset outdoor temperatures.

Continue Reading

Tags: , , , , , ,
Posted in Services | Comments Off on Heating Replacement Tip: Signs of an Undersized Furnace

Heating System Ventilation 101: Basic Guidelines from

Monday, January 2nd, 2012

Maintaining Proper Ventilation for Combustion Systems

Anytime you maintain, retrofit, or replace a gas heating system in your Poolesville home you also need to be concerned with air quality. Combustion air is needed by all oil and gas heating systems to support the combustion process. This air is provided in some homes by unintentional air leaks, or by air ducts that connect to the outdoors. The combustion process creates several byproducts that are potentially hazardous to human health and can cause deterioration in your home. You can protect yourself from these hazards, as well as maintain energy efficiency, by ensuring that your chimney system functions properly and that your gas heating system is properly ventilated. In some cases, installing a sealed-combustion furnace or boiler can also help.

Chimneys

Properly functioning chimney systems will carry combustion byproducts out of the home. Therefore, chimney problems put you at risk of having these byproducts, such as carbon monoxide, spill into your home.

Most older gas furnaces and boilers have naturally drafting chimneys. The combustion gases exit the home through the chimney using only their buoyancy combined with the chimney’s height. Naturally drafting chimneys often have problems exhausting the combustion gases because of chimney blockage, wind or pressures inside the home that overcome the buoyancy of the gases.

Atmospheric, open-combustion furnaces and boilers, as well as fan-assisted furnaces and boilers, should be vented into masonry chimneys, metal double-wall chimneys, or another type of manufactured chimney. Masonry chimneys should have a fireclay, masonry liner or a retrofitted metal flue liner.

Many older chimneys have deteriorated liners or no liners at all and must be relined during furnace or boiler replacement. A chimney should be relined when any of the following changes are made to the combustion heating system:

When you replace an older furnace or boiler with a newer one that has an AFUE of 80% or more. These mid-efficiency appliances have a greater risk of depositing acidic condensation droplets in chimneys, and the chimneys must be prepared to handle this corrosive threat. The new chimney liner should be sized to accommodate both the new heating appliance and the combustion water heater by the installer.

When you replace an older furnace or boiler with a new 90+ AFUE appliance or a heat pump. In this case, the heating appliance will no longer vent into the old chimney, and the combustion water heater will now vent through an oversized chimney. This oversized chimney can lead to condensation and inadequate draft. The new chimney liner should be sized for the water heater alone, or the water heater in some cases can be vented directly through the wall.

Other Ventilation Concerns

Some fan-assisted, non-condensing furnaces and boilers, installed between 1987 and 1993, may be vented horizontally through high-temperature plastic vent pipe (not PVC pipe, which is safely used in condensing furnaces). This type of venting has been recalled and should be replaced by stainless steel vent pipe. If horizontal venting was used, an additional draft-inducing fan may be needed near the vent outlet to create adequate draft. Floor furnaces may have special venting problems because their vent connector exits the furnace close to the floor and may travel 10 to 30 feet before reaching a chimney. Check to see if this type of venting or the floor furnace itself needs replacement. If you smell gases, you have a venting problem that could affect your health. Contact your local utility or Poolesville heating contractor to have this venting problem repaired immediately.

Chimneys can be expensive to repair, and may help justify installing new heating equipment that won’t use the existing chimney.

Continue Reading

Tags: , , , , ,
Posted in Services | Comments Off on Heating System Ventilation 101: Basic Guidelines from

Space Heating vs. an Upgrade to Your Heating System

Friday, November 18th, 2011

If your Spencerville home’s heating system isn’t really cutting it anymore, it may be time to take a step back and consider what your options are. After all, upgrading to an entirely new heating system is a big investment and a large project that will likely disrupt your life at least for a short period of time. However, under certain circumstances it’s the best alternative out there.

One option to consider when you’re unhappy with your home heating situation is supplementing your central heating system with space heaters. These are generally inexpensive and can be placed virtually anywhere in your house or taken with you from one room to another.

Especially if there is a small part of your home that your heating system just doesn’t seem to reach or that you want to keep a bit warmer than the rest of the house, space heaters can be an excellent option. They’re small, safe and portable and can easily keep a smaller portion of your home or room cozy and warm.

However, you’ll have to take into account the operating costs of a space heater as well as the initial investment when you’re trying to evaluate the overall cost effectiveness of this option. Most space heaters run on electricity, which often costs considerably more than oil or natural gas. If your home heating system runs on electricity anyway, this might not be so much of a factor. But if you have an oil or gas furnace, you could wind up paying significantly more to run space heaters as supplemental heat over time.

Also, it’s worth considering that new home heating systems are likely much more energy efficient than the system you currently have in place. Although the initial installation cost can be pretty substantial, you’ll wind up saving a very large amount on your monthly heating bills by upgrading to a newer model.

Plus, you’ll be getting a system that should be able to satisfactorily heat your home without the need for space heaters or other supplemental heat sources. This translates into a pretty hefty savings over time and that’s something you’ll certainly have to take into consideration when you’re evaluating your options.

Continue Reading

Tags: , , , , ,
Posted in Services | Comments Off on Space Heating vs. an Upgrade to Your Heating System